SLC-DJ60W (40W) ELECTRIC ROLL-UP UNIT Operation Instructions

Characteristics and Application:

SLC-DJ60W (40W) Electric Roll-Up Unit is developed and produced by Beijing Sanlicom Technology Company.  Replacing traditional manual roll-up unit to reach high speed automation in revolving & releasing films and greenhouse environment, it is the new generation of greenhouse ventilation and temperature regulation facilities.  Portability, output torque, output lock, wide range and precise adjustment, waterproof, dew-proof and power-saving are the key characteristics for SLC DJ60W (40W) Electric Roll-Up Unit, which is the best choice for modern daylight greenhouse applied in different climates.

                                     

Parameters:

Model No.

SLC-DJ60W

SLC-DJ40W

Work Voltage

DC24V

DC24V

Work Current

3.5A

3.0A

Max Output Current

5.0A

4.5A

Work Power

60W

40W

Max Output Torque

60N.m

40N.m

Revolving Speed

≈3.8rpm

≈3.8rpm

Max Revolving Rounds

≥55 rounds

≥55 rounds

Adjusting Precision

≤2mm

≤2mm

Length of Rolling Film

≤60m

≤40m

Exterior Dimension

239L * 102W * 131H (mm)

227L * 102W * 131H (mm)

Weight

2.6Kg

2.4Kg

Sidewall Roll Up – Guide Tube Installation Sketch:

To meet different needs, the guide tube could be installed on either side of the unit and regulated at the appropriate height with the Roll-Up Unit.  (Please install the guide tube on a reverse side if you need it in a counter direction.)

Roof Roll Up – Telescopic Tube Installation Sketch:

Rolling Tube Installation Sketch:

Power Supply Requirement:

1.    DC24V power supply or 24V accumulator jar is required.

2.    The power supply should be provided with anode and cathode reversing switch.

3.    Before the Unit starts to work, the reversing switch should be in the status of  Stop”

Distance Setting Operation Instructions: (See below sketch)

                       

1.        Loosen two Lock Screws on Distance Setting Knobs; regulate the Bosses of the Adjusting Alligator Ring not to press on the Contact Points of Inching Switch.   Turn on the power while pulling the reversing switch, at this moment confirm the two directions on reversing switch for “Forward” and “Backward”.

2.        Put the reversing switch on “Backward” and regulate either knob to make it press on the Contact Points of Inching Switch (You’ll hear the sound “crack”).    If the Unit stops working, the knob is defined to “Backward”, the other one for “Forward”.  Likewise, if the Unit continues working, the knob is defined to “Forward”, the other knob for “Backward”.

3.        Put the reversing switch on “Backward” status, turn the “Backward” knob to adjust the distance, and then tighten the Lock Screw with Cross Screwdriver. Likewise, put the reversing switch on “Forward” status, turn the “Forward” knob to adjust the distance, and then tighten the Lock Screw with Cross Screwdriver.

※     Attention: Loosen the Lock Screw with Cross Screwdriver before adjusting distance setting, and tighten it after confirmation!

Warnings:

1.        Keep caution during transportation and installation.

2.        Do not overstep the Max Output Torque.

3.        Do not disassemble the Unit by yourself but contact us for any help needed.